"AllData Editors Note: Customers have reported success using the following spark plug wire placement on the coil pack."

*

Firing order 1-4-2-5-3-6


You are watching: 2004 ford ranger 3.0 firing order


*

Hello,This sounds like it can be the crankshaft angle sensor. Here is the information you needed and a guide to help us see what else can be wrong:https://www.jajalger2018.org/articles/car-cranks-but-wont-startFiring order1-4-2-5-3-6.Check out the diagrams (below).Please let us know what you find. We are interested to see what it is.Cheers, Ken
*

*


Do I need a special tool to replace the 02sensor? Do I need to drop the exhaust pipes to do it too? I am trying to find out what I am up against before I start the project. I was told the by the emissions tech that the "bank 1 sensor 1" was bad. I went and purchased the sensor and was told by the friendly parts pro that bank one is on the side that the #1 cylinder is on, passenger side, or if your Ford dextrous, left side. Have I been given the proper info or have I been fed a load?
On 3.0 and 3.3 its the passengerside....02 is the first one you come to closest to the block, there is a socket made for the job, how much help it will be? They either come out easy, or they pull threads with em!

*

Firing order for 3.3 is 1-2-3-4-5-6

*


My husband is trying to figure out the firing order for spark plug replacment and also wires looked at a few diagrrams but could"nt make sence out of it. Needless to say he is a bk yard mechanic in what particular order do the plugs and wires go? Don"t know where plug # 1 goes front or back, pls help we don"t have money for mechanic disabled and he can"t read. Any help would be greatly appreciated
3.0L and 4.0L Engines Firing order: 1-4-2-5-3-6 Distributorless ignition system

*

Let me know if your engine size is different than 3.0L or 4.0L as this will change the firing order sequence..Thanks for using jajalger2018.org!
Coil pack need to be spun 180 to have the correct firing order on some models.

*

I was able to find this for you. Let me know if it helps. Crank sensor location is attached below, in case you need it.
Trying to figure out the spark plugs wiring diagram so I can change my spark plugs correctly. Any pictures would be greatly appreciated.
Good morning,I attached a picture of the firing order and the location of the wires for installation for you below.https://www.jajalger2018.org/articles/how-to-change-spark-plugsLet us know if you have any other questions.Roy


See more: Have You Ever Seen The Rain Meaning, By Creedence Clearwater Revival

I asked you some questions last week about my truck. I ran in to high water going 55 mph and was able to drive it home but it wouldn't go over 30-40 mph. Next day it wouldn't start. I have got it started one time since then but I ran in my house to grab something and it shut off when I was in the house and wont start since. Okay, I have replaced plugs, wires, distributor cap, rotor, fuel filter, ignition coil and coil wire. I didn't put on new parts two guys did and I'm not confident in their ability so I am going to check the firing order for plug wires on distributor cap. Can you please tell me the proper firing order for my truck listed above. It only has four spark plugs not eight. Also, how do I take off throttle body to expose butterfly so I can spray starting fluid in it to try to get it to fire up? Thank you very much, Brenda Merritt.