I"ve checked out this trouble elsewhere, yet I haven"t uncovered a solution. I need to remove the lens from mine fluorescent light fixture so i can adjust the bulbs. It shows up the only means to eliminate the lens would be come remove among the end caps top top the fixture so the lens might slide out. Yet I can"t see any way to remove the end caps. To eliminate them, it shows up the pressure that would be required may be an excellent enough to break them. I"ve never ever seen together a poor style for a basic device. Ns could post photos if that would help.

You are watching: How to remove fluorescent light fixture cover


*


Pic"s always help. Many times you just need to flex the clear cover over one side, climate it comes right off.

The lens extend well into the finish caps. Over there is no way sliding the lens either way and climate flexing that would allow it to it is in removed.
Sometimes you obtain lucky and also the entirety frame w/lens lifts and also can be jiggles loose. Otherwise, that is a game if angles and patience. Shot to acquire one side as high as feasible while pulling down on the other. Execute this after the light has been on because that a while so the plastic lens is a tiny warmer and not together brittle. I"ve had success, I"ve likewise had to replace a couple that were much less than cooperative.
My guess is the one or both end caps breaks on and can be eliminated by tapping it near the ceiling to popular music it turn off the fixture. The lens would then slide out, giving you accessibility to the tubes.
I"ll try tapping one finish cap off. So far I"ve only been trying to pry that off. Together I mentioned, slide the lens fully into either end cap walk not enable the opposite end of the lens to come everywhere near dropping down.Added: goldstar wins! The plastic finish caps are organized to the fixture with two protruding tabs on each side that the end cap. Unfortunately, tapping lightly on one end damaged these plastic tabs off. Ns don"t care!I currently see the correct method is to press very firmly in top top the end of the steel fixture to deform that area so these tabs would certainly then clear the steel fixture"s holes. With the end cap off, the lens slides out.

See more: How Many Players On A Baseball Field, How Many Players On A Baseball Team


Too bad you had actually to break the tabs off one finish cap to find out the trick, but, happy you gained it resolved and thank you because that the feedback.
I installed a pair of new 6000K daylight tubes and also the area looks an excellent now. So lot so, I want to change the various other two still functioning tubes in a surrounding fixture. Fortunately, that is lens has a ridge on each side that simply lifts up turn off the fixture. I"m an experienced now!
I love those. I forget what remained in our to wash room once we bought this house, however I immediately replaced whatever it was v two two-tube T-8 fixtures, one 4" and also one 2", joined end-to-end, and installed 6500K lamps (I think lock are) in them. That"s 120W that daylight appropriate down the facility of the room. If girlfriend don"t view a point out on the clean garments in the room, you certain won"t view one what else!Hey! walk for it, expert!
*
*

jajalger2018.org®, established in 1995, is the leading independent home advancement and fix website. Us welcome her comments and also suggestions. All details is listed "AS IS." Website operating problems contact webmaster